Hello Angela, Your drawings look very good but in the elevations there is a problem with the dimensions.
Normally in elevation we limit vertical measurements and in plan horizontal measurements, we do not mix.
On the other hand, in a simple drawing, it is preferable, although not mandatory, that all dimensions are aligned outside the drawing, at the margins.
I share a link: http://recursosinterior.blogspot.com/2013/12/acotar-correctamente-en-autocad.html
In your inner axonometric, you do not need to dot the lines where you have cut the walls but to make those lines thicker because they are cut lines.
3 comentários
displayname1013793
Professor PlusHello Angela, Your drawings look very good but in the elevations there is a problem with the dimensions.
Normally in elevation we limit vertical measurements and in plan horizontal measurements, we do not mix.
On the other hand, in a simple drawing, it is preferable, although not mandatory, that all dimensions are aligned outside the drawing, at the margins.
I share a link: http://recursosinterior.blogspot.com/2013/12/acotar-correctamente-en-autocad.html
In your inner axonometric, you do not need to dot the lines where you have cut the walls but to make those lines thicker because they are cut lines.
Greetings and congratulations
Visualizar original
Ocultar original
displayname296718
@isabelmabascal thank you for the comments and for the support material, I have already adjusted the work with the recommendations you made.
Visualizar original
Ocultar original
displayname1013793
Professor PlusGreat Angela. Congratulations and I hope that your new knowledge will help you a lot.
Cheers
Visualizar original
Ocultar original
Faça login ou cadastre-se Gratuitamente para comentar